The Australian Knifemakers Guild aims to promote, preserve and develop the craft of knifemaking and all its various disciplines to the highest standard possible. Members regularly meet at knife shows to share ideas and inspiration on their latest creation.

Joining the guild is a great way to improve your skills and networks as a custom knifemaker. Probationary members must meet certain standards of fit and finish on their blades before being accepted as full members.

For more information see their website at www.akg.org.au 

This is a one day introductory course in making pattern welded (damascus) steel.

After an introduction to metallurgy and theory of pattern making, you will begin forge welding a 20 layer billet of 1055 and 15N20 steel, using our hydraulic press. Once fused into a single block and drawn out, it will be cut into three, restacked and welded into a 60 layer billet. This is repeated untill you have a 180 layer billet.

The billet will then be cut in half and a different pattern worked into each piece before drawing out the billets to their final shape. They are then ground flat and acid etched to reveal the pattening.

The course goes for one day from 9am until 5pm. For starting dates of next courses see the upcoming courses list on the side panel.

Cost - $440 (incl GST)

It is not necessary to have previous experience in forging for this course. You will keep the billets made for future projects.

There is a limit of only two places per course.